Two types are provided to meet with your particular requirements.
- Straightening and cutting machine for ribbed wire
- Straightening and cutting machine for cold drawing wire
Straightening and cutting machine for ribbed wire
This machine is developed for cut-to-length rods with accurate length and good surface quality. The cutting system has two types. One by pneumatic clutch is suitable for mesh welding machines, and the other by servomotor-driven flying shear is ideal for frequent rod length changes. It is stilled equipped with a freely programmable control system for easy operation.
Technical parameters:
| Components | Technical specifications |
| Wire diameter | Φ 6 - 12 mm for round wire and cold-rolled ribbed wire |
| Φ 6 - 10 mm for hot-rolled ribbed wire | |
| Straightening speed | 75-100-130 m/min |
| Scope of length | 800mm---12000mm(also can be adjusted by customers) |
| Linearity of straightening | ≤2mm/m |
| Cut-to-length tolerance | ±1mm |
| Total rated power | 26KVA, 380V-60Hz |
| Total weight | 4 tons |
| coil pay-off | Vertical plate, With brake system by compressed air |
| trumpet | Bell-mouthed |
| straightening unit | Straightening blocks, turning unit |
| Cutting unit | Special mechanical unit, clutch by compressed air |
| Discharge and collect unit | 12 m in length, driven by compressed air |
| Signal seat for cutting |
Straightening and cutting machine for cold drawing wire
Applied for cold drawing wires - ferrous and non-ferrous. Wires can be cut to the desired length automatically.
Technical parameters:
- Wire diameter: 3.5 ~ 6.0 mm
- Scope of length: 3000 ~ 8000 mm
- Straightening motor: 3KW
- Cutting motor: 1.5KW
.jpg)
.jpg)
