Performance and the difference between similar products
I. Seven characteristics
1. Vertical feeding directly in place.
2. Die static, roller rotating, materials centrifugal, evenly distributed around.
3. Double-layer dies, up and down dual-use, reduce the cost, enhance the efficiency, can be dual-use, high capacity, energy saving.
4. One die, different hole diameters, with different specifications to pelletize.
5. Macroporous die, wire joining circular tube, increasing travel, improving density.
6. Ring die, vertical structure, good for cooling the pelletizing room.
7. Independent and frequency conversion discharge device, to ensure that the rate of pellet formation.
Either difference
1. Upward mould, special structure, vertically feeding, easier heat dissipation: the material is feuded into the pelletizing room vertically and is well placed; no other pressing device is needed.
(1) Die rotates to make rollers run, the output will be effected as material is easily arched which lead to uneven feeding.
(2) When the rollers rotate while the die is static, which could avoid the arching of material, but centrifugal force is caused which will swing the material in the pelletizing room to the periphery.
2. Die static, roller rotating, material centrifugal and distributed around evenly: using a unique double-layer high rebounding-effect die, naturally and evenly distribute in the die's inner surface.
3. Double layer die, multifunction, high efficiency: die has upper parts and lower parts, customers
can choose two different specifications of apertureto produce different specifications of pellets.
