Dual Gun unit. Bothoperators each have a powder coating gun, control unit and powderinjector that use powder from the same box.
0-100 Digital Adjustable KV
Fully Adjustable Amperage
Fully Adjustable Amperage
Fully Adjustable Air for Pump on Pressure, Dosage and Nozzle Rinsing Air.
Comes with Full Array of Nozzle Assortment.
Field Tested and Proven to operate in the toughest environments.
Comes with different array of delivery systems:
Because this system is specially balanced for the maximum spray capability with
the Smoothest Finish Possible.
Comes with Full Array of Nozzle Assortment.
Field Tested and Proven to operate in the toughest environments.
Comes with different array of delivery systems:
Because this system is specially balanced for the maximum spray capability with
the Smoothest Finish Possible.
Configuration:
1pcs optistar control unit power supply cable
- 1pcs air filter
- A air pressure regulator
- 1pcs suction tube
- 1pcs plug-in injector
- 1pcs optiselect manual powder gun with gun cable, powder
hose, rinsing air hose and standard nozzle set.
- Pneumatic hoses for conveying air (red), supplementary
air (black) and fluidizing air (black)
powder hose
Ground wire
Structure:
Technical data:
Electrical data
Mains input voltage: 220V/110V
Operating frequency: 50Hz /60Hz
Powder: 50W
Output voltage (to the gun): 0-100KV ( adjustable)
Maximum output current (to the gun): 180UA(max)
Protection type: IP54
Approvals: CE Certification
Pneumatical data
Input pressure: Min. 6 bar(87PSI)/max. 10 bar(145PSI)
Recommended input pressure: 7 bar(101.5PSI)
Max. Water vapor content of the compressed
Air 1.3 G/m 3;
Max. Oil vapor content of the compressed air 0.1 mg/m3;
Dimensions
Carton size: 120x79x73cm G. W: 55kg.
Theprocess of the coating is like this :the powder is fluidized in thepowder hopper. The injectors transport the powder through the hoses tothe guns . The guns spray a powder/air mixture onto the workpieces.
Powdercoating is a type of coating that is applied as a free-flowing, drypowder. The main difference between a conventional liquid paint and apowder coating is that the powder coating does not require a solventto keep the binder and filler parts in a liquid suspension form. Thecoating is typically applied electrostatically and is then cured underheat to allow it to flow and form a "skin". The powder may be a thermoplastic or a thermoset polymer.It is usually used to create a hard finish that is tougher thanconventional paint. Powder coating is mainly used for coating of metals, such as "whiteware," aluminium extrusions, and automobile and bicycle parts. Newer technologies allow other materials, such as MDF (medium-density fibreboard), to be powder coated using different methods.
The powder coating process involves three basic steps:
- Part preparation or the pre-treatment
- The powder application
- Curing
