Starway LED Ultimate Lightbar for Police Construction, EMS

LED3520 LED Ultimate Lightbar for Police Construction, EMS

1. Summary

This product adopts double-layer aluminum alloy boards' structure, which has distinct outline stronger percussion-resistant capability, and is not easy to lose color and get aged. Moreover, the light bar has good sealing and waterproof. A lot of LED lights are distributed shapely and use high power LED lights let it give out strong flash light from each direction. And it has advantage with high brightness and low power waste. It has 11 kinds flash pattern and six direct lights. It can be installed on all kinds of special vehicles. Even in extremely complicated, circumstances, it can transmit emergency signal correctly.

2) Specifiation:

3)Packing Information:

4)Installation of the warning light bar

a) Put light bar on the vehicle's roof, base on the vehicle's size, adjusting the frame to fit it, And Then let the catches button the rainwater line on both side of the vehicle and screwing the nut by wrench. (See. Figure 1 below)

b) After installed, firstly, according the color, plug the six wires one by one to the controller, ensure every wire not to meet each other, then connect the two main red and black electrical wires to the battery (red to +, black to -) ( see: figure 3 )

NOTICE: the controller connection should must be made before it connects to battery. And must use insulating tape tie up every of six wires of controller, ensure they can not to short. Otherwise the controller will be damaged.

c)After checking, then turn on the power of controller to work the light bar.

Figure 1. INSTALLATION OF THE LIGHT BAR

5. Controller

5.1. The power switch that on the one side of the controller is control the power supply of the light bar and controller.

5.2. Switch LEFT ALLEY control the left alley light. Press one time for lighting; press again for turn off.    

5.3. Switch RIGHT ALLEY control the right alley light. Press one time for lighting; press once more for turn off.

5.4. Switch TAKE DOWN control the front lights. Press one time for lighting; press once more for turn off.

5.5. Switch Full Flashing control the 18 PCs flashing lights to flashing or turn off.

5.6. Switch change the main flashing lights to backward a pattern.

5.7. Switch change the main flashing lights to next a pattern.

5.8. Switch ← control the direct lights flash towards left. Press once for turn on, press once more for turn off.

5.9. Switch ↑ control the direct lights to flashing. Press once for turn on, press once more for turn off

5.10. Switch → control the direct lights flash towards right. Press once for turn on, press once more for turn off

5.11. Switch FLASHING LIGHTS control the 12 PCs flashing lights to flashing. Press once to flashing, press once more to turn off.

Figure 2. CONTROLLER

Figure 3. WIRING

ATTACHED FORM 1

Note: ¤flash, ●dark

Workshop:


Applications:
Police, Fire, The Automotive, Police, Fire, Motorcycle, Construction,Emergency Vehicle and School Bus Industries