Touch Button 180WS Digital Studio Flash Light
QUICK START GUIDE
- Mounting on the light stand
Select a stand or support system of suitable weight and dimensions to ensure stable operation of the unit. - Fitting the modelling lamp and flash tube
Check that the modelling lamp voltage is correct.
Ensure that the unit is switched off and disconnected from the supply. Confirm that the lamp and flash tube are securely fitted, particularly before first use or after transporting the unit. - Connect the sync cord to the socket (10).
- Power supply connection
Be sure that the power switch (6) is set to OFF. Use the cable equipped with the unit to connect to AC supply. A 3-wired, grounded supply system should be used for safe reason. - Adjust the Flash/Modelling lamp to provide the desired settings and select any options by pressing the switch.
Now you can start to use the unit.
SPECIFICATIONS
Type |
M180 |
Power Output |
180WS |
GN (ISO 100) |
40 |
Power Setting |
From 1/16 to Full (0.1f-stops/step) |
Recycle Time to full |
0.3~2.3s |
Flash Duration |
1/1500~1/600s |
Modelling Lamp Output |
75W (Diffused Halogen) |
Flash release |
Slave Sensor(cell)/Synch Cable/Test Button |
Ready display |
Visual and audible signals when 100 % of selected energy is reached |
Color Temperature |
5600K±200K |
Flash Beam Width |
55° |
Flash Tube |
Plug-in Flash Tube (easy replaceable) |
Synch Voltage |
5V |
Cooling |
Natural cooling and Temperature sensor protection |
Power Source |
AC200V-240V 50Hz/60Hz |
Amperage of Fuses |
5 A |
Dimension (L x W x H) |
45cm x 21cm x 27cm |
CARTON CONTAINS
- 180WS Flash Body 1pcs
- 75W Modeling Lamp 1pcs
- Power Cable 1pcs
- Synch Cable 1pcs
- Instruction Manual 1pcs
FLASH CONTROLS AND OPERATION
The flash power is adjustable over a 4 f-stop range (5 f-stops) from 1/16 to full in 1/10 increments using the Power regulator down (12) and Power regulator up (11) push buttons. The power is displayed in an easy to use decimal form where each whole number represents 1 f-stop. The control has a minimum setting of 2.0 and a maximum setting of 6.0. A single press of either the UP or DOWN button changes the value by 0.1f-stop (1/10) to give a total of 50 values. (E.g. If the current value shown is 5.4, then to reduce the power by 1 f-stop just reduce it to 4.4.). With a long pressure on the energy control keys "up/down", the setting changes in intervals of ten. The Table as follows shows the whole decimal numbers and equivalent fractional power ration:
Displayed Power |
Fractional Equivalent |
6.0 |
Full |
5.0 |
1/2 |
4.0 |
1/4 |
3.0 |
1/8 |
2.0 |
1/16 |
Note:
When you adjust the power range from higher GN to lower, the unit will be triggered automatically to flash for discharging and then recharge until the GN you displayed.
CONTROL PANEL DIAGRAM
CONTACTING INFORMATION
E-mail: info@simockphoto.com.cn
amandalee@simockphoto.com.cn
Skype: amanda_cn
Contacting: Ms. Amanda Lee (Export Manager)