Aluminum 860 Lumen LED Backup Diving Torch With 70min Runtime
Advantage Features:
- Made of aircraft-grade aluminum with hard anodized finish/ black color , vacuum coating aluminium reflector + Ultra clear tempered glass;
- Rotary switch on the neck part;
- Waterproof: IP-68
- Anti-roll, slip-resistant body design
- 860 Lumens
- Magnetic Push switch is convenient for the scuba diving.
PRODUCT SPECIFICATIONS
Model | W16S Diving Light |
Bulb | Cree XM-L U2 (Max 860 lumens) |
Color temperature | 6500 K |
Output Function | High> Off |
Runtime | 70 min. |
Reflector | Glossy Aluminum reflector |
Body material | Durable aircraft-grade aluminum |
Angle of light beam | 8° |
Surface treatment | Premium Type III hard-anodizing |
Color | Black |
Battery | 18650 Li- ion battery * 1 |
Circuit Protection | With battery over-discharging protection, polarity reversing protection |
Operation voltage | 3.0V to 4.5V |
Low voltage alarm | flash 3 times when the voltage is below 3V and flash 3 times again in 5 second, then change to 10% brightness till switch off when the voltage is below 2.8V |
Waterproof | 100 meters underwater |
Dimensions | 145(length)*24(dia. of end)*29mm (dia. of head) |
Weight | 115grams (without battery); 165 grams (with battery) |
Underwater Weight | 135 grams (with battery) |
Impact resistance | 1.5M |
BATTERY INSTALLATION
- Separate the light head and body by turning counter-clockwise.
- Remove used batteries and replace with fresh batteries as shown by the polarity stickers.
- Mount the light head on the body by turning clockwise.
BATTERY CHARGING
- Plug the charger in the wall power socket, the indicator light is green in the free-load status.
- Put the battery in the slot of the charger.
- The indicator light is red if the battery is not fully charged; it will turn green after fully charged.
- Take out the fully charged battery and use them in the diving light.
ON/OFF
Push the switch forward to turn the light on.
Push the switch forward again to turn the light off.
SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.