Mitsubishi/KUM auto 10 pin female connector replace for PB625-10027
The wire specifications used in the automotive wiring harness are those with labeled sectional area 0.5, 0.75, 1.0, 1.5, 2.0, 2.5, 4.0 and 6.0 (in Japanese automobiles, the labeled sectional areas are 0.5, 0.85, 1.25,2.0, 2.5, 4.0, 6.0 square millimeters, etc. Each of them has a value that allows the load current, matching for conductors for different power electrical equipment. Take the wiring harness of automobile for example, 0.5 specifications are applicable to instrument lamp, pilot lamp, door lamp and top light, etc.; 0.75 specifications are applicable to license plate lights, before and after lights, stop lamps, etc.; 1.0 specifications are applicable for turn lights and fog lights, etc.; 1.5 specifications are applicable for fore-headlight and horn, etc.; main power lines, such as generator armature wire, earth wire, etc., require wires with specifications from 2.5 to 4. These are just for normal automobiles, it's maximum current value of load that matters, such as the earth wire and positive power wire of storage battery should be used solely for specific car wires with large wire diameter, which is at least above ten square millimeters, these "giant" wire will not be incorporated into the main wiring harness.
Product Description
|
Before the permutation of wiring harness, its drawing ought to be laid out first, the wiring harness drawing is different from circuit principle diagram. The later reflects relations between various electrical parts, not to reflect how the parts are connected to each other, and is not influenced by size, shape of electrical components and their distance from each other. While wiring harness drawing must take the above factors into consideration, and reflect how electrical parts are connected to each other.
Selection principle
Electrical
Current requirements: high current, low current, signal level; determine the type of terminal / contact segment size / electroplate (pin and common terminal from 0.64mm and 8.0mm); steady state, cycle, transient wire diameter / insulation requirements: voltage drop and / or corrosion resistance; determine the center distance of connector
Location/environment
Temperature: the engine compartment - seal, ambient temperature >105oC, vibration, fluid compatibility, passenger compartment - non sealed, ambient temperature <85oC, size factors are more important
Seal: potential high pressure spray / splash; potential immersion; humidity; fluid type; for equipment connectors, check whether equipment is sealed
