Submersible Most Efficient Low Speed Propeller Mixer IP68 Protection Grade
Operation conditions:
Flow propeller can work normally under the following conditions:
1) Maximum media temperature not exceeding 40;
2) PH value of media within 5-9;
3) Fluid density not exceeding 1150kg/m3;
4) For long term of submersed operation, submergence not exceeding 20m generally;
Attention: The equipment should be operated completely under water, and can not be
operated in flammable or explosive environment or environment with highly corrosive liquid.
Features:
| 1 | The two rows of independent mechanical sealing ensure the long-term and reliable operation of the submersible motor. |
| 2 | The international well-know high-quality bearings have longer service life, which is maintain free. |
| 3 | The in-built leakage sensor and the device for the over temperature protection for the windings of the stator. |
| 4 | The supporting fram and the lower support shall be fixed onto the pond wall and the pond bottom with the use of expansion bolts or chemical anchors. For the big diameter impellers and the big power mixers the best choice is to pre-embed. |
| 5 | A multiple of mixers with the same installation system can share one lifting system. |
| 6 | The submersible mixers can be installed in a multiple of modes. |
Construction:
| No. | Name | Material | |
| GB | JIS | ||
| 1 | Propeller | FRP | FRP |
| 2 | Output shaft | 2Cr13 | SUS420J1 |
| 3 | Wheel boss | HT200 | FC200 |
| 4 | Mechanical seal | SiC-SiC | SiC-SiC |
| 5 | Mechanical seal stand | HT200 | FC200 |
| 6 | Decelerator | HT200 | FC200 |
| 7 | Leakage sensor | - | - |
| 8 | Bearing stand | HT200 | FC200 |
| 9 | Bearing | - | - |
| 10 | Sheath | HT200 | FC200 |
| 11 | Motor shaft | 2Cr13 | SUS420J1 |
| 12 | Slide sleeve | HT200 | FC200 |
Project reference:
