Industrial Gas-Filled Air Spring:
H series Airspring:
BELLOWS : Wall gauge is approximately5 mm.
GIRDLE HOOP: Wire wound type shown, molded into the bellows.
BEADRING: upper and lower. countersunk steel type shown. May also be of a secondstamped steel variety or made of aluminum.
AIR INLET: 1/4BSP parallel is standard. 3/4BSP parallel is also available formost parts.
BOLT: M10 x 45 mm Used for mounting the part.
MOUNTING PLATE:The plates must be strong enough andbacked by structural members to prevent bowing of the forces or loadsinvolved
Jseries Air spring:
BLIND NUT: M8 x15 (two or four per each plate depending on part size). Used for mounting thepart.
MOUNTING PLATE:The plates must be strong enough andbacked by structural members to prevent bowing (of the forces or loadsinvolved
AIR INLET:1/4BSP parallel is standard. 3/4BSP parallel is alsoavailable for most parts
Kseries Air spring:
BLIND NUT: M8 x15 (two or four per each plate depending on part size). Used for mounting thepart.
MOUNTING PLATE:The plates must be strong enough andbacked by structural members to prevent bowing (of the forces or loadsinvolved.
AIR INLET:1/4BSP parallel is standard. 3/4BSP parallel is alsoavailable for most parts.
ZFseries Air spring
BLIND NUT: M8 x15 (two or four per each plate depending on part size). Used for mounting thepart.
MOUNTING PLATE:The plates must be strong enough andbacked by structural members to prevent bowing (of the forces or loads involved.
AIR INLET:1/4BSP parallel is standard. 3/4BSP parallel is also availablefor most parts.
CYseries Air spring
BLIND NUT: M8 x 15 (two or four pereach plate depending on part size). Used for mounting the part.
AIR INLET:1/4BSP parallel is standard. 3/4BSP parallel is also available for mostparts.
We believe that we can be your ideal partner!
Your friendly enquiry would be highly appreciated!
