Rear Carbon Air Spring
Products
H series Air spring:
BELLOWS : Wall gauge isapproximately 5 mm.
GIRDLE HOOP: Wire wound type shown, molded into thebellows.
BEAD RING: upper and lower. countersunk steel type shown. May alsobe of a second stamped steel variety or made of aluminum.
AIR INLET: 1/4BSP parallel is standard. 3/4BSP parallel is also available formost parts.
BOLT: M10 x 45 mm Used for mounting the part.
MOUNTING PLATE:The plates must be strong enough andbacked by structural members to prevent bowing of the forces or loadsinvolved
J series Air spring:
BLIND NUT: M8x 15 (two or four per each plate depending on part size). Used for mounting thepart.
MOUNTING PLATE:The plates must be strong enough andbacked by structural members to prevent bowing (of the forces or loadsinvolved
AIR INLET:1/4BSP parallel is standard. 3/4BSP parallel is alsoavailable for most parts
K seriesAir spring:
BLIND NUT: M8 x 15 (two or four pereach plate depending on part size). Used for mounting the part.
MOUNTINGPLATE:The plates must be strong enough and backed bystructural members to prevent bowing (of the forces or loads involved.
AIRINLET:1/4BSP parallel is standard. 3/4BSP parallel is also available for mostparts.
ZF seriesAir spring
BLIND NUT: M8 x 15 (two or four pereach plate depending on part size). Used for mounting the part.
MOUNTINGPLATE:The plates must be strong enough and backed bystructural members to prevent bowing (of the forces or loads involved.
AIRINLET:1/4BSP parallel is standard. 3/4BSP parallel is also available for mostparts.
CY series Air spring
BLIND NUT: M8 x 15 (two or fourper each plate depending on part size). Used for mounting the part.
AIRINLET: 1/4BSP parallel is standard. 3/4BSP parallel is also available for mostparts.
We believe that we can be your ideal partner !
Your friendly inquiry would be highly appreciated !
