Description:
Work width:360mm(14 inch)
Punch tickness:35sheets
Pith:2:1 /12.7mm
Disengagement punch pins:27
Number of punch pins:27
Binding thickness:380sheets
360mm work width accept larger than A4 size paper, such as 14"
Full 27 disengageable punch dies with hard steel for clean punch hole
A diameter sticker on the machine guide you to select the correct wire dimeter
Manual Punch & BindingMachine with two seperated handle,one for punching, one for binding
2:1&3:1Wire Binding Machine
wire hangercompartment
The paper load is horizontal and has a margin guide to assist the user with the work being done.
Maximum binding capacityup to 380 sheets with 2:1 wire,punch up to 35 sheets per time
Technology Data:
MaxBind Capacity (20# paper) | 380Sheets |
Max Punch Capacity (20# paper) | 35Sheets |
Binding Format | Wire |
Punching Method | Manual |
Binding Method | Manual |
Punching Format (Vertical/Horizontal) | Horizontal |
Punch and Bind Capability | Yes |
Max Punch Length | 360mm |
Max Binding Length | 360mm |
Number of Punch Pins | 27 |
Disengageable Die Pins | 27 |
Waste Compartment | Yes |
Side Margin Control | Yes |
Products Detail:
Dcument masure:according to your files thickness to pick the right size of wire .
Knob of wire size: can be adjustable according to your sheet thickness and wire size
Seperate Punching &binding handle:Seperate punching &binding handle ensure your sheets are on the same line and feed the sheet horizon ,push the binding handle
Select punch pins: disengagement punch pins made ofhard steel for a clean hole punch
Selectable paper stop: according to you files' zise, select paper positon ,keeping sheet aligning ,we have position for A4 ,11" ,14"
Waste tray: large volume waste tray make you continuious work without empty punched times
After long term use if it unbalance of closing bar , we will show you to fix it with a small tool in serveral simple steps as below:
1.
2.
3.
Loosen the two screws as indicated on the diagram a and b for one circuit only .
Check the unbalance of two closing bars by ruler or by eye then adjust the screw to left or right as
Check the unbalance of two closing bars by ruler or by eye then adjust the screw to left or right as
indicated on diagram accordingly .
Then test binding to check if the adjustment is ok or not .
Then test binding to check if the adjustment is ok or not .
If not perfect ,repeat as above until the perfect balance
So ,it is really a durable machine can last for many years .
So ,it is really a durable machine can last for many years .