The CL-131S electrostatic powder manual coating equipment with the
COLO-07 manual powder gun is ideally suited for manual coating of objects in larger series.
Theprocess of the coating is like this :thepowder is fluidized in thepowder hopper. The injectors transport thepowder through the hoses tothe guns . The guns spray a powder/airmixture onto the workpieces.
Typical characteristics
- Processing the powder from the fluidized powder hopper
- Quick and simple color change
- Supplied ready for use
- Available with one or two guns (extensible)
Technical Data
Electrical data
Power range 100-240V
Frequency 50HZ /60HZ
Temperature range in use -10 ℃+50 ℃
Powder Gun
Gun weight: ^^^ 500G
Rated output voltage ^… 24VDC
Input voltage ^^… - 200kv
Maximum output current ^… 180Ua(max)
Maximum output voltage^^ 0-100KV ( adjustable)
Maximum powder injection :^… 600g/min
Polarity ^^^ negative (-)
Pneumatic data
Maximum input-air pressure ^^.. 10kg/cm
Optimum input-air pressure^.. 6kg/cm
Minimum input-air pressure ^ 4kg/cm
Maximum water vapor content or compressed air ….. 1.4g/N m3
Maximum oil vapor content of compressed air ^.. 0.1ppm
Maximum compressed-air consumption^… 13.2 m3/h
Dimensions
Width | 690mm |
Depth | 800mm |
Height | 1135mm |
Weight | 45kgs |
Manual coating equipment-structure
1 control unit 2 Manual powder gun
3 injector 4 Mobile frame with hand rail (trolley)
5 Fluidized powder hopper
8 Filter unit
9 Gun holder
11 Hose holder 12 Hose holder
13 Rubber wheel
WARNING
--INSTALLATION
→Propery ground all equipment in the spray area to an earth ground and maintain this ground
→Remove all containers of volatiles from the spray area
→Establish and maintain a grounded area for the spray operator
→The gun of x series must be connect to x control unit
→OPERATION
→The operator should hold the gun in his bare hand
→If gloves are worm ,the palm should be out to assure skin to metal contact
→The operator should wear shoes with conductive shoes e.g leather
Rubber shoes are not conductive .
→Ground the tip of the gun before cleaning or changing nozzles.
→When the gun is not in use , it should be hung so that the nozzle is within four inches of a grounded conductor
→The operator should wear a filter-type respiator anytime he is exposed to dusty conditions
→High pressure powder many cause injury ,Keep the rear switch "off" position in no –use condiction
→MAINTENANCE
→Make a periodic confirmation of grounding to earh of all equipment in the spray area .
→Exercise good housekeeping practices , do not allow dirt or powder to accumulate on the feeder /powder unit , cable or gun.
→Keep the cabinet door
PERSONNEL
→Use saop and water to remove powder from the skin washing with solvents can cause reactions resulting in allergies and disourders.
→Wash hands before eating and smoking.
→Do not use compressed air to blow poder off the hands and clothing.
This practice may result in damage to the ear drums or eyes.
2. INSTALLATION
→Connects the control units MAIN AIR to MAIN AIR(REGULATOR) output unit with air hose
→Connects the control unit DOSING AIR to INJECTOR with air hose
→Connects the FLUIDIZING AIR (REGULATOR )output unit to HOPPER with air hose
→Connects the control unit AUXILIARY AIR to GUN with air hose
→Connects the POWDER HOSE to INJECTOR
→Connects the GUN CABLE to CONTROL UNIT with air hose
→Connects ground connection cable from ground nut to the booth and trolly
→Connect main powder cable
