DNC 50*100 pneumatic cylinder price
MOQ:1 PCS price US 22.2
20-50 Price US19.98
51-100 price US18.50
1 pneumatic Cylinder using conditions
(1) Pneumatic cylinder using the system pressure, medium temperature should be consistent with the basic parameters of pneumatic cylinder models specified value table.
(2) The compressed air must be clean drive cylinder, less water, this circuit must be used in the gas manifold filter.
In order to lubricate the cylinder internal loop in the pneumatic system lubricator must be used (no oil lubrication cylinder can not)
2 Cylinder Installation
(1) cylinder should be checked before unpacking the cylinder for damage during transportation, nuts or threaded rod ends for loose connections, remove rust oil and protective cover (cap) before installation
(2) the cylinder piston rod cylinder installation should pay attention not withstand eccentric loads or lateral loads, should make the load axis line direction of movement of the piston rod consistent load for long stroke cylinder and piston rod connected to the best use of the V-type connector can be active or joint head. Whatever the cylinder base installation must ensure there is sufficient rigidity.
(3) When used in a horizontal cylinder block, use "three-point method" for testing. First, the piston rod connected to the load, when the piston rod is fully extended, to put a water level in the bar intermediate level observed situation; secondly in the intermediate position when the piston rod, the piston rod is in close proximity to the piston rod at the eye level to put a water level situation; Finally rod in the retracted position, should no other fresh phenomenon. Long-cylinder horizontal installation, in order to prevent the piston rod sagging, deformed cylinder shall be properly supported.
(4) Front and rear flange, tripod-mounted cylinder, fitted bolts should avoid direct exposure to pushing or pulling loads.
