Garden Submersible Pump

WORKING PRINGCIPLE
Pumps are open impeller centrifugal SUBMERSIBLE DRAINAGE PUMPS,designed for automatic use.The impeller,mounted on the end of the drive shaft,consists of a back disk and blades.The fluid enters the rotaing blade channel via the suction strainer,where it moves radially from the centre outwards,acquiring energy both in the form of pressure and increased speed.When it leaves the impeller the fluid is conveyed into the volute.Here part of the kinetic energy is transformed into pressure energy and the fluid leaves the pump via the vertical delivery opening in the pump body.Correct motor cooling is ensured by the fluid being pumped.

PUMP INSTALLATION AND APPLICATIONS
Pumps are suitable for lifting clear water not containing abrasive substances.These pump have been designed for easy use and are extremely reliable even when subjected to continuous use(e.g.in fountains),since the notor is fully cooled and has an ample reserve of power plus a double seal. The motor and the pump are easily removed,making maintenance and repair more simple.
THESE PUMPS ARE PARTICULARLY SUITABLE FOR DRAINING FLOODING IN CONFINED AREAS (BASEMENTS,GARAGES,ETC.),EMPTYNG SWIMMING POOLS.TANKS AND AQUARIUMS,WASTE HOUSEHOLD WATER DISPOSAL(DISHWASHERS,WASHING MACHINES),SUPPLYING GAREDN FOUNTAINS SMALL-SCALE IRRIGATION FOR GARDENS IN GENERAL FROM COLLECTION TANKS AND EMPTYING SUMP PITS.

PERFORMANCE
When designing performance levels for pumps,special attention was given to typical requirements for domestic usage.
1.performance curves specially designed for high delivery rates at the low installed power rating.

STRUCTURAL CHARACTERISTICS
1.DELIVERY BODY made from fibre glass reinforced technopolymer,particularly to mechanical stress,knocks and corrosion,fitted with 11/4" gas threaded vertical delivery opening.
2.SUCTION STRAINER made from fibre glass reinforced technopolymer,providing the support base for the pump.
3.Technopolymer HOSE JOINT with screw fitting.
4.Technopolymer open IMPELLER.
5.EXTERNAL FLOAT SWITCH for automatic pump operation
6.stainless steel MOTOR SHAFT.
7.DOUBLE SEAL carbon/alumina on the pump side and sealing ring on the motor side.
Sealed induction MOTOR,suitable for continuous duty with built-in thermal cutout relay(motor protector).INSULATION Class B(provides the motor with a considerable overload tolerance and substantially increases the service life of the motor itself).
8.PROTECTION IP68.
9."H05/07 RN-F"Neoprene submersible SUPPLY CABLE,Supplied standard with 10 meters of cable and plug.
10.CONSTRUCTION AND SAFETY STANDARDS in compliance with EN60335-2-4li,EN60335-li,EN60335-1/A16.