Summary:
This is a medical diode lipolysis laser system for Minimally Invasive Weight Loss Surgery, dental cleaning, spider and varicose veins treatment,which was developed and manufactured by WWINBEAUTY. With years tested and improved,the system has a high effiency of fat removal and long lifetime.
Theory:
Lipolysis laser has become a increasingly hotter slimming methods in the past decade. It is a Minimally Invasive Weight Loss Surgery.During lipolysis treatment, a very thin cannula (1mm wide hollow metal tube) is pushed through a small incision in the skin. The laser light is conveyed into the fat layer using a 1-mm microcannula (OSYRIS) which incorporates a 600μm or 400μm optical fiber.Then the fat cells are transformed into an oily sludge-like substance or 'debris' which is eventually eliminated by the body. Fat removal treatment by 980nm diode lipolysis laser is much faster than that by cold laser and Vacuum Cavitation System. Even the next day after treatment,most people can feel the treated area(s) fat reduction when
squeezed between the fingers.Power differs in different treated areas: 6W (chin, arms, knees), 10W (abdomen, back), and 15W (thighs, hips, buttocks). Transcutaneous illumination by the aiming beam ensures precise visualization of the region where the energy is delivered.
Lipolysis Laser is considered as an effective, minimally invasive solution for fat removal and body reshaping. Its functions lay in the ability to treat localized fat deposits and correct body asymmetries with apparent decreased risks compared to traditional liposuction. The energy emitted by the laser uses volumetric heating to destroy fat cells, contract skin and stimulate collagenesis. It has been found that 980nm diode laser is successful in inducing the required fat-heat and skin-heat interactions necessary for optimal results.
Specifications:
Paramete | Value |
Central Wavelength | 980nm |
Spectra Width | +/-5nm |
Typical Output Power Ex-Fiber | >=20W |
Connector | SMA-905 |
Bridge Fiber | 600um / NA=0.22 |
Peak Power | 5%, 10% ~ 100% |
Pulse Width | 15ms~500ms |
Repetition Rate | 1Hz~10Hz |
Operation Mode | CW / Pulsed |
Pilot Laser | 5mW / 635nm |
Expected Life Time (MTTF) | >50,000 hours |
Surgery Fiber Suggested | 600um / 800um, NA=0.22 |
Pedal Switch | Support |
Dimension | 36.5x36.5x16.5cm |
Weight | ~7.5KG |
Input | 110VAC / 220VAC, 50~60Hz |
Serious Notice for therapeutist:
1. Always keep the laser and fiber in a clean environment to avoid dust.
2. Clean all the dust on the fiber ends and output coupler before you use the laser.
3. Remove the output coupler's cap when you are going to install the fiber.
4. Remove the caps on the fiber ends when you are going to use it.
5. Clean the both fiber ends with alcohol + cotton ball before you use it.
6. Do not keep the fiber ends or output couplers in the air for too long time.
7. Do not plug-in & plug-out the fiber frequently.
8. No need to remove the fiber every time you finish the treatments. Just keep the fiber connected and this can avoid
dust into the output coupler.
9. If you don't use the laser for a long time, you can remove the fiber and put the caps on.
10.A local anaesthesia must be used in the area to be treated before commencing.
