YG10X Tungsten Rod Carbide Tungsten Solid Rods Surface Ground For End Mills
Carbide tungsten rods are mostly applied for end mills with sub-micron grain grade YG10X.
Brief Introduction of Carbide Tungsten Rods:
Standards: GB, ANSI etc.
Recommended Grade for tungsten carbide rod: YG6, YG8, YG6X, YG10X, YG013, YG11C etc
Carbide tungsten rods applications include drill bits, end mills, and reamers.
Spcecification: φ0.8--60mm Length: 330mm
Advantages of Carbide Tungsten Rods:
100% Virgin WC material.
Sizes as per your requirements
Fully adopted in advance technology and equipment
Professional manufacture for carbide tungsten products
Quality Control System and strict inspection
Dimensions and Tolerance of Standard Carbide Tungsten Rods Blanks:
|
Dimension & Tolerance |
||||
|
D diameter (mm) |
L1 Lengthmm |
L2 Lengthmm |
D Diameter Tolerance |
L Length Tolerance |
|
Dia. 1mm – 4mm |
310 |
330 |
+0.15 ~ +0.60 |
+0.00 ~ +10.00 |
|
Dia. 5mm – 10mm |
+0.20 ~ +0.70 |
|||
|
Dia. 11mm- 35mm |
+0.25 ~ +0.80 |
|||
Carbide Rods Material Grades:
|
Grade |
Applications |
|
YG6 |
Good hardness and normal strength, for drawing of steel and non-ferrous metal and alloy bars or tubes under the condition of higher Stress. |
|
YG6X |
High wear resistance and high hardness,for drawing of steel wires and non-ferrous metal wires or alloy bars under low-stress condition. |
|
YG8 |
High wear resistance and high hardness,for drawing and straightening steels,non-ferrous metal and alloy bars and tubes; And for fabricating of machine parts,tools and wear parts,such as nozzles,centres,guiding devices,upsetting dies and perforating tools. |
|
YG8X |
Good strength and impact toughness; suitable for plates,bars,saws,seal rings,tubes etc. And it is one of the most popular grade for wear parts. |
|
YG15 |
High Strength and impact toughness, but lower hardness and wear resistance.For drawing steel rools and pipes under high stress condition;And also for upsetting dies and perforating tools under higher impact loading. |
|
YG20 |
Used as wear parts,sheets and some mechanical components. |
|
Suggestion: We would like to recommend suitable grade depending on your machining materials. |
|
Picture show:
