|
Main Parameter |
Be subject to the final and approved design |
|
Meas. of Furnace Shape |
20000mm×2500mm×3500mm ( The length of Curing Section is 13m) |
|
Max rated curing temp. |
330 |
|
The speed of convey |
v=0.250.45m/min |
|
Width of the mesh-belt |
1000mm |
|
Effective height of throat |
300mm |
|
Gas heating capacity of |
300000Kcal/h |
|
Installed capacity |
25.2KVA |
|
Operation Panel |
Touch Screen / English & chinese Language |
|
Temperature controlling |
±5 |
Operational process of curing technique Loading → levelling→ pre-heating → curing → cooling and unloading
Struction and descriptions
Mainly structured of Loading and uncloading sections , HL Cooling System,Convey Unit,Body, Hot Blast Air Generating and Circulating Systems, Electric Control System and so on. It is specially designed for Geomet coating ( and suitable for any other brands zinc flake coating , no matter water-base or solvent-base paint ). High-automaticly controlled with the speed of mesh-blet regulated, it can fully satisfy all curing processes.
Loading Section:
Here the loading platform and convey unit is designed. In order to have smoth coating layer, the suitable distance of levelling is considered.
Unloading Section:
Here the unloading platform and convey unit is designed.
Cooling system :
The function of HL Cooling System ,made up with Cooling Cell,Supplying and exhausting fans and air duct, is to enforce cooling the parts cured. High outer rotor centrifugal fan is adopted. And the thermal insulation is set up at the exit and entrance of the cell.
Convey Units
The drive chain (40Mn) , φ27 seamless steel up-hold tube3, stainless steel mesh-belt ( fit for M6) ,reduction box , tension device, drive sprockets, drive shaft and track .
Body
Here the body contains Wet-bleeding system and Hot Blast Air Generating and Circulating Systems, and including :
The Body contains Pre-heating and curing two sections. Pre-heating mainly gets rid of the wet in low tempreture and curing section solidifys the coating layer in high tempreture. All the tempretures in these two sections can be regulated and controled. 180mm thickness aluminium silicate is filled between inner-wall (1.5mm stainless steel plate) and outer-wall (1.5 mm cold rolled plate ). In order to reduce heat channel and ensure thermal expansivity , all plates inside and outside are not sealed.
