Introduction:
LS-R324 is a 1W radio modem, transmit 3km LOS. It supports UHF band, 24V power supply. Usually works as DTU to connect with PLC and other industrial control devices. LS-R324 Supports RS485 Modbus RTU protocol. Has the advantage of register data restore function.
Application:
Water/waste water treatment field
Wind speed, rainfall, humidity etc data collection
Temperature, humidity, concentrations of CO2 etc data collection
Wireless data collection and transmission
Wireless communication between PLC and sensors
Power output: 24V DC
RF power: 1W
Air baud rate: 1,200/2,400/4,800/9,600/19,200bps choose one
Interface baud rate: 1,200/2,400/4,800/9,600/19,200bps programmable
Frequency band: 433, 450, 470 or others
Interface: Standard RS-232/RS-485/TTL/USB
Communication mode: Half-duplex
Channel: 8(default), 16/32(customized)
Receive current:<45mA (TTL connect)
Receive sensitivity: -123dBm @ 1,200bps); -118dBm @ 9,600bps)
Transmitting current:<500mA
RF line-of-sight range: 2km (BER=10-5@9600bps); 3km (BER=10-5 @ 1,200bps)
Size: 175*115*32mm (without antenna port)
Parameter:
Frequency | 433MHz or 450MHz, 470MHz |
Power Output | 1W(3000m LOS) |
Protocol support | Standard Modbus RTU protocol or user-defined protocol |
Power supply | 9-36V DC usually use 24V DC or 12V DC |
Interface | RS-485(default)or RS232 or USB |
Channel No. | 15 channel, use DIP to change |
Antenna | Free sucker antenna with 1.5m cable(buy 5.5dBi sucker antenna) |
Temperature | -35℃~+75℃ (industrial) |
Dimension | 175×115×32(mm) exclude antenna |
Fix method | Screw |
Pin Definition:
Support RS232, RS485, USB, you can use DIP switch to program
About channel setting
Channel No. | DIP Setting | Channel No. | DIP Setting | Channel No. | DIP setting | Channel No. | DIP setting |
1 | 1234 | 2 | 1234 | 3 | 1234 | 4 | 1234 |
5 | 1234 | 6 | 1234 | 7 | 1234 | 8 | 1234 |
DIP1 ON means 1
DIP2 ON means 2
DIP3 ON means 4
DIP4 ON means 8
For example, channel 15, you need to set DIP 1, 2, 3 and 4 all ON
About the LED indicator
a. When module is power on, POWER LED is always ON (red).
b. When module enter to set mode (DIP 8 ON), SET LED is always ON (red).
c. When module is transmitting,
if you use RS232 port, RS232 LED blinks (green) regularly.
if you use RS485 port, RS485 LED blinks (green) regularly.
if you use USB port, USB LED blinks (green) regularly.
d. When module is receiving, RF LED blinks (blue) regularly.
Advantage of wireless solution
- No wires to bury or maintain, no need to drill holes on wall
- Reliable communication in all direction,any terrain, regardless of hills, walls, trees
- Cost saving in installation and maintenance
- Radio based, no need internet and monthly fee, full ownership of the system
- 4G based, high speed, no distance limit