Small toilet paper making machine adopt advanced PLC technology,variable speed adjustment,electronic braking,and touch screen operation control panel.Also the machine is newly added coreless roller shaped rewinding system.It's adopt PLC wind pipe-shaped new technology.It's no need to put core or stainless sheel pipe It's full upgrade the whole machine.
Small toilet paper making machine for toilet paper and kitchen paper
Automatic paper tube replacement device, do not need artificial wear paper tube, and then finish rewinding and sent out the finished product, immediately reset rewinding, can adjust at will within 1 minute any kind of specifications of paper tube.
2. Automatic trimming, spray adhesive and sealing a complete synchronization, finished with 10 to 18 mm paper tail, convenient opening, reduce the wastage of the ordinary paper rewinding mechanism make tail,and thus reduce the product cost.
3. Adopts international advanced PLC programmable controlling technique,man-machine interface operation, data set and parametric fault shows on touch screen.
4. High precision spiral soft knife,4 knife punching low noise, punch more clear, gearbox the adjusting range is large.
5. Three layers of horizontal paper back frame, pneumatic on paper, pneumatic wide belt paper, each roll of base paper were independent adjustment device,paper is soft,
6. Embossing device, using point-to-point double embossing system, make the finished product two-sided effect, embossing clear and beautiful(Required customer specified)
JN-BFJ1092Y-1 TOILET PAPER REWINDING MACHINE | |
Apply base paper | Base paper requirements:14-23g/㎡ 2 to 3 plies |
Base paper width:Max 1350mm | |
Base paper dia:Max ￠1500mm | |
Base paper core Dia:￠76mm | |
Paper feeding | One unwinding stand with two feed belts,buffer cylinder control |
Manual tension adjusting device | |
Pneumatic jumbo roll loading | |
Full embossing unit | One set of steel to rubber embossing rollers,the embossing must be clear,and the pattern should be confirmed by both sides |
One set of arc-shaped bar unit in order to make the paper smooth and wrinkle-free | |
Handpiece unit | Production speed:0-200 m/min which up to the operator |
Finished core dia:￠35-50mm which controlled by the operator | |
Finished paper roll dia:￠60-130mm | |
Perforation with spiral cutter,the regular pitch is 120mm,chain wheel positioning | |
Automatic paper core dropping device | |
Automatic tail trimming ans sealing | |
Control unit | Frequency control of motor speed |
Automatic counting | |
PLC control system | |
Power:AC380V 50HZ,3Phase | |
Air pressure:0.5Mpa | |
Accessories | Tool box,1pc(containing the basic tools) |
Operation manual in English,1pc(containing the pneumatic drawing and electric drawing) | |
