Advantage
- No wires to bury or maintain, no need to drill holes on wall
- Reliable communication in all direction,any terrain, regardless of hills, walls, trees
- Cost saving in installation and maintenance
- Radio based, no need internet and monthly fee, full ownership of the system
- 4G based, high speed, no distance limit
Lensen Wireless RTU features
- Portable device, DIN-rail mounting for easy installation
- Isolated inputs
- LEDs for power supply, communication, input, output status
- Flexible networking, point to point or point to multipoints
- DIP to change different modes
- Different types of I/O, DI, DO, AI, AO are available
- I/O expandable
- Short delay time
- Support I/O reduction, field input, remote output
- Easy handing on RS485 network, support Modbus RTU protocol
- Support on-line upgrade. Can configure by customer in setting mode
Introduction
LS-RDIO0202 Modbus RTU is a 1W I/O module, 2 isolated digital inputs, 2 isolated relay outputs, 1 RS485 (wireless RS485 customizes). Wireless control 2km-3km. Use for pump control, water level monitoring, motor, valve, light ON-OFF control.
Transparent I/O System, no programming required
Not need internet, no third party cell, no monthly fees
You have full control over your own carrier
Real time status feedback from the remote site
Fast installation and easy setup
Parameter | |
Power output: | 1W |
Power supply: | 9V-30V (choose 24V DC or 12V DC) |
Control distance: | 3km or (1km version) |
Baud rate: | 2400bps |
Receiving sensibility: | -123dBm@1200bps, -118dbm(9600bps) |
Networking | |
Networking: | Point to point and point to multipoint |
Port Description | |
Input: | 2 digital input |
Output: | 2 relay output, contact AC250V/5A,DC30V/5A |
Communication port | RS485 (wireless RS485 customize) |
Current | |
Transmit current: | <600mA (or 40mA version) |
Receiving current: | <50mA (or 20mA version) |
General | |
Frequency: | 433MHz,450,470 or other band |
Channel No: | 15 channels, can change via DIP switch |
Physical Properties | |
Dimension: | 115×90×40(mm) |
Weight: | 300g |
Antenna Connector: | SMA,vehicle antenna with 1.5m cable |
Temperature: | -35℃~+75℃( industrial) |
Mounting method: | Standard 3.5 inch industrial guild rail |
