Home > Electronic & Electrical > Power Distribution Equipment > DC Brushless Motor Driver BLDC - 5015A

ShenZhen HSM stepper Motor Electric Co., Ltd

[Province: Guangdong ]

Contact Method

DC Brushless Motor Driver BLDC - 5015A

Share |

DC Brushless Motor Driver BLDC - 5015A

HiSupplier Escrow

Add to My Favorites

Trade on HiSupplier, Worry Free Guarantee

•Trading safety, secure your money, lower the risk, protect both buyers and suppliers

•HiSupplier is a Chinese multinational company in U.S, it helps to coordination and order landing.

More ›

Product Details
Company Profile
Product Reviews

Brushless DC Motor Speed Driver BLDC-5015A Features

SPWM, Speed/Current alike close loop technology, smooth rotation
Smooth torque output within speed range (8000 rpm Max.)
1:75 Max. speed regulation ratio
60°/300°/120°/240°Electrical angle adjustable
Speed regulation: potentiometer adjust / Analog input
Run/Step, Quick Brake, CW/CCW rotation shift
Speed output, Alarm output(O.C.)
Over current, over voltage, stall, missing speed Alarm

Parameters

Electrical Parameters(Tj25ºC)

Power	2450VDC, Capacity:up to motors
Current output	Rated 15A, Peak 45A(≤3s)
Driving mode	SPWM
Insulation Res.	500MΩ
Dielectric Strength	500V/Minute
Weight	About 300g

Ambient requirement

Cooling	Self cool
Environment	Keep away from oil, dust, and acid gas
Temperature	0ºC50ºC
Humidity	80RH
Vibration	5.7m/s2.Max.
Storage temp.	20ºC125ºC

Function description

Power Supply: DC+ ; DC-

Voltage: 2450DC, normally Linear Power Supply applied(appendix), ripple voltage higher than 50V may damage driver. The output current of LPS shall be 60more than that of driver. In case of switching power supply(strongly recommended)applied, please pay attention to the current shall meet motor’s current.
Attention: incorrect connection may cause driver damaged.

Speed regulation choice(RV ; AVI)

1.Setup speed by potentiometer (RV).The dipswitch SW2 must be ON status to enable this function. CW rotate the potentiometer will increase speed. CCW- speed down.

2.Setup speed by analog input (AVI). The dipswitch SW2 must be OFF status to enable this function..AVI terminal accept 05V voltage or PWM signal from controller.AVI terminal with input resistance of 100K, current consumption≤5mA.

Reference table

SW2

Command to

Speed adjust

Comman

Current

CW—speed up, CCW—speed down

Send message to this supplier