Wet pasting method: it is suitable for wrapping large vehicles (two-person working together is recommended)
The procedures and tools: water sprayer, clean rag, flake flattener, snap-Off Knife, blow dryer
• After the vehicle body is cleaned, spray water on the area you paste with the paster by water sprayer– which is mainly used to reduce viscosity of the paster, and facilitate the position adjustment.
• Once the pasting position is confirmed, strip up the paster along with the transfer film (the transparent film which is adhered on the Reflective wrapper), from right to left (or top to bottom), press and flatten them onto the vehicle body with rag, at the same time, peel off the release paper..
• Regarding to the handle or the bumper strip, cut off or enfold the paster according to the circumstance.
• Timely adjust the position of the graphics, repeatedly scrape off the bubbles and water with flake flattener from right to left in an oblique way after the position of the graphics is confirmed, and finally remove the transparent transfer film.
• Cut off when coming to the door and joint with snap-Off Knife, and paste the paster inwards wherever possible.
• Dry the water underneath the paster as much as possible, and use the blow dryer to heat moderately if the condition allows.
Suggestion: We suggest neither to solarize the vehicle within 24 hours, nor to wash it within 48 hours as far as possible.
The procedures and tools: water sprayer, clean rag, flake flattener, snap-Off Knife, blow dryer
• After the vehicle body is cleaned, spray water on the area you paste with the paster by water sprayer– which is mainly used to reduce viscosity of the paster, and facilitate the position adjustment.
• Once the pasting position is confirmed, strip up the paster along with the transfer film (the transparent film which is adhered on the Reflective wrapper), from right to left (or top to bottom), press and flatten them onto the vehicle body with rag, at the same time, peel off the release paper..
• Regarding to the handle or the bumper strip, cut off or enfold the paster according to the circumstance.
• Timely adjust the position of the graphics, repeatedly scrape off the bubbles and water with flake flattener from right to left in an oblique way after the position of the graphics is confirmed, and finally remove the transparent transfer film.
• Cut off when coming to the door and joint with snap-Off Knife, and paste the paster inwards wherever possible.
• Dry the water underneath the paster as much as possible, and use the blow dryer to heat moderately if the condition allows.
Suggestion: We suggest neither to solarize the vehicle within 24 hours, nor to wash it within 48 hours as far as possible.
