Solo Tidy Cut Sealing Machine for Sterilization Rolls

(a).The packages can be sealed consecutively without waiting, pre-heating time only 2-3minutes.
(b).12mm seal width assure additional safety, Ergonomically formed reel dispensers enable effortless re-feed of the sterilization packaging.
(c).The integrated cutting unit allows the user to adjust packaging to the size of the instruments and thus individual practice requirements.

Power input	AC110V/230V  50/60Hz
Pre-heating	2~3minutes
Power	100W
Isolation	I/IPX0
Type of sealing	At constant temperature
Sealing length	30cm
Sealing width	12mm
Gross weight	7.5kgs
Package Dimensions (WxLxH)	460*360*170mm
Environmental temperature	+5 / +40 °C
Relative max. humidity	85%
Max voltage variation	± 10 %
Pollution level	1

3-Instruction

(a) Connect the power cord to the power connector which is on the back side of the sealer, check if the voltage of your equipment matches the voltage of the local electrical network.

(b) Switch the sealer on by using the power switch on its back side and adjust the sealing temperature through the temperature selector on its right side according to the thickness of the material to be sealed. When the green LED goes off (after around 2 minutes) the sealer will be ready to be used.

(c)Place the roll on the holder. The beginning of the roll shall be inserted through the back side, between the pressure bar and the sealing bar always with the paper side down (resistance's side)and the plastic side up (directly under the upper pressure bar). Pull the sealer arm towards the operator and press it down softly until it is locked. Exaggerated pressure may break the sealer arm and this kind of damage is not covered by the warranty. The sealing time (around 4seconds) must be manually controlled by the user. Note: If the sealing temperature is too low or too high the sealing might be inefficient (the envelopes may be stuck to the sealing area when they are pulled or be visibly badly-sealed). To correct this, adjust the timer properly. Once adjusted it is not necessary to perform any other adjustment to continue sealing.

(d) To cut the packages, still with the arm locked, slide the blade from one side to the other, raise the sealer arm and remove the envelopes.Note: If the blade knob is pulled slowly the paper may crease and the cutting will not be adequate. To make it more precise, pull the blade knob quickly. If necessary, slide the cutting blade more than once.

Problem	Possible Cause	Solution
The led flashes red	The machine is heating and the temperature is not sufficient for correct sealing.	Wait for the fixed green light when the machine is ready to be used.
The led is fixed red and there is an intermittent acoustic signal.	The maximum sealing time has been exceeded and the handle has remained down.	Lift the handle immediately.

5-Payment details
T/T, L/C & west union acceptable.

6-Shipment