DM2280A 2 Phase Ac Stepper Motor Driver
Specifications
votage range:110VAC-220VAC
current range:3.2A-8.0A
high performance digital stepper motor driver
AC motor driver
DM2280A AC stepper motor driver features:
1. high performance
2. over current, over voltage, under voltage, over heating, autmatic semi-flow prection fuctions
3. anti-noise, low vibration
4.dimensions: 198mm × 76mm × 130mm
5. drive all the 2 phase and 4 phase, curret under 8.0A stepper motor
6. Working environment: temperature: 15-40, humidity <90%
Driver functions descriptions
|
Driver function |
Operating instructions |
|
Output current setting |
Users can set the driver output current by SW8-SW10 three switches. The setting of the specific output current, please refer to the instructions of the driver panel figure. |
|
Microstep setting |
Users can set the driver Microstep by the SW1-SW5 five switches. The setting of the specific Microstep subdivision, please refer to the instructions of the driver panel figure. |
|
Single/double Pulse setting |
SW7 sets pulse mode, setting “on” as double pulse mode, setting “off” as pulse + direction mode. |
|
Self-test setting |
When SW1-SW5 five switches are all on “off”, the driver will test the motor normal or not according to the inner 1KHZ pulse. |
|
Automatic half current function |
Users can set the driver half flow function by SW6. "OFF" indicates the quiescent current is set to half of the dynamic current, that is to say, 0.5 seconds after the cessation of the pulse, current reduce to about half automatically. "ON" indicates the quiescent current and the dynamic current are the same. User can set SW6 to "OFF", in order to reduce motor and driver heating and improve reliability. |
|
Signal interfaces |
PUL+ and PUL- are the positive and negative side of control pulse signal; DIR+ and DIR- are the positive and negative side of direction signal; ENA+ and ENA- are the positive and negative side of enable signal. |
|
Motor interfaces |
A+ and A- are connected to a phase winding of motor; B+ and B- are connected to another phase winding of motor. If you need to backward, one of the phase windings can be reversed. |
|
Power interfaces |
It uses AC power supply. Recommended operating voltage is 110VAC-220VAC, and power consumption should be greater than 500W. |
|
Indicator lights |
There are two indicator lights. Power indicator is green. When the driver power on, the green light will always be lit. Fault indicator is red, when there is over-voltage or over-current fault, the red light will always be lit; after the driver fault is cleared, if re-power the red light will be off. |
|
Installation instructions |
Driver dimensions:198×76×130mm, please refer to dimensions diagram. Please leave 10CM space for heat dissipation. During installation, it should be close to the metal cabinet for heat dissipation. |
