Section Bender Metal Bender Machine With Processing Equipment
Quick Detail:
A MATERAIL WINDING MACHINE CLW24S-16
|
Angle leg-out |
Max. Cross-section (mm) |
80x80x6 |
|
Min. Bending diameter(mm) |
1500 |
|
|
Angle leg-in |
Max. Cross-section (mm) |
70x70x6 |
|
Min. Bending diameter(mm) |
1500 |
|
|
Flat-along edge |
Max. Cross-section (mm) |
150x25 |
|
Min. Bending diameter(mm) |
1200 |
|
|
Flat-along face |
Max. Cross-section (mm) |
75X16 |
|
Min. Bending diameter(mm) |
800 |
|
|
C-section leg out |
Model |
12 |
|
Min. Bending diameter(mm) |
1700 |
|
|
C-section leg in |
Model |
12 |
|
Min. Bending diameter(mm) |
1500 |
Description:
--Three driven rollers
--bending rolls are high tensile alloyed forget steel, heat treated
--all welded steel frame, heavily proportioned and stress relieved
--digital read outs for the position of the lower rolls
--The three-roll double-pinch type uses one fixed roll and two moveable rolls. Rolls adjust to bend symmetrically or asymmetrically and pre-bend both ends of the work piece in a single pass. Bending distance-the distance between the tangent contact points of the rolls- increases with diameter rolled, broadening the capacity of the machine.
--guide rolls are hydraulic driven and adjustable in up/down
--shafts in alloyed steel, heat treated and grinded, mounted on long life grease lubricated self-alignment spherical roller bearings
--with emergency stop buttons
-- All motors have corresponding breaker to protect for short circuit caused by over electricity
--All motors have corresponding heat relay as protection against overload
Applications:
This machine is widely used in the petroleum, chemical industry, water and electricity ,shipbuilding and machine manufacture and so on .
Functions and Features
this type section bender is used in the volume curved angle steel .channel steel ,I-steel. Flat steel .side steel. Round steel and so on .each kind of profiled bar
