Specification should care about :
Model No | KW17A-WCDMA | ||
Parameter data | Uplink | Downlink | |
Frequency Range | UL:1920-1980mhz | DL:2110-2170mhz | |
Output Power | 17 ±2dBm | 17 ±2dBm | |
Gain | 65 dB | 65 dB | |
Bandwidth | Wide Band | ||
Automatic Gain Control | >20dB | ||
Ripple in Band | ≤5dB | ||
Intermodulation Products | 9KHz~1GHz | ≤ -36 dBm | |
1GHz~12.75GHz | ≤ -30 dBm | ||
Spurious Emission | 9KHz~1GHz | ≤ -36 dBm | |
1GHz~12.75GHz | ≤ -30 dBm | ||
Noise Figure @ max. gain | ≤ 6 dB | ||
VSWR | ≤3 | ||
MTBF | >50000 hours | ||
Power Supply | AC:90~265V, 50/ 60Hz;DC:12V 3A | ||
Power Consumption | < 20W | ||
Impedance | 50 ohm | ||
Mechanical Specification | |||
RF Connector | N-Female | ||
Cooling | Heatsink Convection cooling | ||
Dimensions (D x W xH ) | 135*105*26mm | ||
Weight | 0.7kg | ||
Installation Type | Wall Installation | ||
Environment Conditions | IP40 | ||
Humidity | < 90% | ||
Operating Temperature | -10°C ~ 55°C | ||
How to install repeater (very easy and simple):
Step1: Use your mobile phone to test signal strength outside house or on roof, 70dbm is the basic requirement (full bar).
Step2:Install outdoor antenna in that location and keep adjusting, point it to signal tower station, try to get best signal.
Step3: Run outdoor coaxial cable into building in a convenient location to connect with signal repeater.
step4: Mount your indoor antenna with signal repeater
step5: Power up signal repeater device to check the signal inside, moving outdoor antenna until you get satisfied signal.
Note: Connect outdoor ANT (BTS) port with outdoor antenna, connect indoor ANT(MS) port with indoor antenna, outdoor antenna is mounted at a higher position. Both antennas should be
10 meters far away from each other at least.Indoor and outdoor antenna must be separated by wall.
