Contact person: joanna
Skype:dongda007
Tel: +86-537-2902388 Fax: +86-537-2902388
E-mail: joanna@dongdamachinery.com
Address : West of Zhixue Road,High-tech Zone,Jining City,Shandong Province,China
Mine pneumatic submersible pump Introduction:
Mine pneumatic submersible pump is developed by our company can be a new product, this product USES coaxial rotor and the pump body connection of mechanical products, the vertical structure, the pump.
FQW series pump is suitable for the dangerous sites containing gas and coal-dust explosion drainage operation, can be widely used in the coal mine for any operation todeliver a pulverized coal, the sediment particles of groundwater, the use of safe, reliable, and effectively improve the air quality.
Mine pneumatic submersible pump Technical characteristics
Mine pneumatic submersible pump compact structure, moving, installation, maintenance is convenient. Pump body vortex street with high efficiency and energy saving hydraulic model, special impeller design. The water pump sewage discharge ability is strong, large flow, high lift, etc
Mine pneumatic submersible pump Product structure & working principle
Mine pneumatic submersible pump: Pump body, gas motor and Over current.
1 Pump body parts: consists of two cavity, with sealing ring to separate gas and water in the middle. With spring seal, seal ring and use of gas and water pressure, the high pressure gas and water respectively into the upper and lower two sealing ring lining, make them up, enhance the sealing effect.
2 Mazda parts: by the rotor, turbines, bearings, etc.
3 The over-current parts: by the water wheel, volute, pump cover, pump seat , etc. Wheel is installed on the vortex shell lumen rotor shaft, compressed air from the air inlet into the rotor drive wheel, the water in the turbine under the action of centrifugal force, the pressure into the volute out the water snails were, the discharge outlet pipe.
Mine pneumatic submersible pump Working environment:
1. Have gas and coal dust in the air
2. Working pressure is 0.4-0.7MPA
3. The PH of water in 4-10
4. Density of water is not more than 1.1 * 103 kg/m3
5. Working environment temperature (5 ~ 40)°C
