Home > Electronic & Electrical > Passive Components > PCB & PCBA > PG Structure Atmel Touch Screen Glass Panel for GPS Car Navigation

SUNCENT TECH GROUP LIMITED

[Province: Guangdong ]

Contact Method

PG Structure Atmel Touch Screen Glass Panel for GPS Car Navigation

Share |

PG Structure Atmel Touch Screen Glass Panel for GPS Car Navigation

HiSupplier Escrow

Add to My Favorites

Trade on HiSupplier, Worry Free Guarantee

•Trading safety, secure your money, lower the risk, protect both buyers and suppliers

•HiSupplier is a Chinese multinational company in U.S, it helps to coordination and order landing.

More ›

Product Details
Company Profile
Product Reviews

PG Structure Atmel Touch Screen Glass Panel for GPS Car Navigation

Quick Detail:

Cover PET+ITO Glass+FPC
Sensor Process: Photo etching
Size: 15.4 inch
IC: 1664S-AT (COF)
Interface: I2C
Operating System: Android

TP Specification:

Model No.	SCT-PA5-205695A
Structure	PG
Surface Hardness	3H
Size	15.4 Inch
Active Area	331.2 x 207 mm
Outline Dimension	351.6 x 228.6 mm
ITO Glass	1.1 mm
Cover PET	0.25 mm
FPC	Pitch=0.5 mm
Interface	I2C
Work Voltage	2.8-3.3 V
Connection	COF
IC Model	1664S-AT
Operating System	Android
Transparent	≥87%
Operating temperature	-2070, ≤90%RH
Storage temperature	-3080, ≤90%RH

Assembly Precautions:

Do not exert extra force to touch panel.
Since touch panel is transparent and clear,make sure to wear fingerstall or glove before touching.Be careful of your hands and other parts from injury at handling by glass corners.
When installing and assembling, do not lift tail with heavy force to avoid tail peeling off touch panel.
When handling,make sure to hold the touch panel borders not center parts to avoid dirt to touch panel. Do not lift touch panel by tail to avoid tail loosen.
Do not stick or mount other parts on the tail, such as additional film or metal plate. As it will exert extra force to tail tip and cause tail loosen.
Please don't pull FPC with force from side to side, because the FPC tension will make FPC burst.
If there is air groove on touch panel, when design product structure, make sure no liquid and powder near the air groove.
In order to avoid heavy stress to touch panel surface, make sure to keep 0.2mm-0.5mm assembling gap between touch panel and case.

About Us

Main Structure:

GG structure
GG structure uses cover glass plus sensor glass solution, harder than PG structure, high transmittance and good effect for anti-scratch.

PG structure
PG structure uses one PET film plus sensor glass solution. Mature process technology greatly reduces the failure rate and cost. It has the same level weight with OGS structure.

OGS structure
OGS uses one glass solution, directly form ITO conducting film in the protective glass and use the sensor technology. It has the advantage of the simple structure, light, thin and good transmitting etc.

Main Material: