Hotlock Heaters Coil for Hot Runner System
1. Heaters Coil Brief Introduction
- Make the groove according to the heating distribution
- Compatiable with many coil heaters
- Mini interior diameter 6mm
- Mini length of the brass tube 30mm
- Thermocouple K or J available
- Good performance in heating conducting
2. Heaters Coil Characteristics
Standard sizes available with various cross section
Various Watt Density options available.
Robust Design with Choice of Terminal Exits
Designed for even heat profile
Precision fit on Hot Runner Nozzles & Manifolds
Highly Non-corrosive
Maximum heat transfer due to more contact area
Advanced Thermal Engineering
CE Certified
Available with built in Thermocouple
3. Heaters Coil Parameter.
- Standard Configuration
- Material :304
- Unheated length(L1):45mm
- Connector(cold side)(D1xU): 3.5x40mm
- Power lines,grounding wire length(L):1000mm
- Surface treatment:sandblasting;
Spring coil heater (H series) |
2.2x1.5, 2.4x1.6, Φ1.8,Φ2.0,Φ2.5 |
Voltage |
220V,230V,240V |
Power tolerance 115W-200W |
+/-10% |
Power tolerance 201W-2000W |
+5%-10% |
Out jacket length |
30mm~190mm |
Diameter of the inner sleeve/wrapped diameter |
10mm~42mm |
Unheating length |
45mm |
Max power density |
9W/cm² |
Heating Length tolerance |
+/-0.05mm |
Unheating length tolerance |
+/-2.5% |
Tolerance ID d ≤20mm |
Without inner sleeve:-0.15mm |
Tolerance ID d 20mm~30mm |
Without inner sleeve:-0.20mm |
Tolerance ID d ≥30mm |
Without inner sleeve:-0.25mm |
Tolerance cross section |
+/-0.10mm |
Thermocouple |
None |
Material |
304,321,316 |
Maximum working temperature |
650 |
Die electrical strength |
600V |
4. Heaters Coil Application
Hot Runner Nozzles & Bushings.
Hot runner Injection moulds
Injection & Blow Moulding Machine Nozzles.
PET prefrom & Thin wall container Moulds.
Hot Runner Manifolds.
5. Transportation