4500 Watt Cigarette Drum Cutter Machine Electric With Tainless Steel
MC50 Mini Cutter applies to cut lamina/stem with the speed of 200-500kg/h in the pilot line or lab. To make the specification of the processed lamina and stem conforms to the specified requirements of the cigarette craft. The width of cutting is adjustable at the range of 01-3mm easily.
Mini Cutter also applies to the vegetables cutting and processing in the food processing production line with the speed of 500-1500kg/h. To make the specification of the processed vegetable leaves conforms to the specified requirements of the craft. The width of cutting is adjustable at the range of 01-6mm easily.
This cutter is wide scope, easy to use and maintain, advanced control function and with cutting width, speed, material status, fault display, manual and automatic control functions.
Main Technical Parameters
|
No. |
Item |
Unit |
Parameter |
Remrks |
|
1 |
Rated capacity |
kg/h |
100 - 300 |
|
|
2 |
Supplied material moisture content |
% |
20% - 30% |
|
|
3 |
Supplied material temperature |
30 |
|
|
|
4 |
Discharging material temperture |
70 - 95 |
adjustable |
|
|
5 |
Discharging material moisture content |
% |
12 - 14 |
adjustable |
|
6 |
Roller speed |
rpm |
10 - 20 |
adjustable |
|
7 |
Steam pressure |
MPa |
0.8 |
|
|
8 |
Compressed air |
MPa |
0.6 |
|
|
9 |
Installed power |
kw |
4.5 |
|
Supply Instruction
1. Sold in complete machine
2. Main material: 3mm 304 stainless steel cylinder wall, rest is carbon steel.
3. Wires and pipes except for those for the main engine are not within the supply scope.
4. This machine has a moisture- removing air pipe joint. The air pipe flange and dust remover device
should be equipped by the purchaser.
5. The electric motor is featured with simple electronic control, which enables manual valve control of
temperature, moisture and blast capacity.
Operating conditions
a) Relative humidity: ≤80%
b) Ambient temperature: 1040
c) Sea level elevation: ≤2000m
d) Power: 3N50HZ, 380V ± 38V 50HZ ± 1HZ
e) Compressed air: Pressure ≥0.3MPa Flow≥0.2m3/min, after dry and filtration
f) Feeding:
Tobacco: Stem conforms to the 5.5.2 regulations of the , comply with the leaf conforms to the 6.2.2
regulations of the .
g) Metal flush trimmer should be set at the Feed End.
h) Operators shall take professional training, and can be practically operate the machine according to the
requirement standardized of the instruction.
Picture
