Hypertherm HSD130 Nozzle 220530 For Hypertherm Plasma Cutting Machine
Shanghai ZhouBo Welding & Cutting Technology company are a professional manufacturer of plasma cutter consumables, Hypertherm plasma Cutting machine HSD130 accessories, plasma consumables. Hypertherm plasma HSD130 plasma cutting accessories, Hypertherm HSD130 plasma torch parts. Hyperherm plasma cutter nozzle 220489, plasma cutting nozzle 220492, 45A nozzle 220525, 50A nozzle 220530, hyperherm electrode 220525, plasma cutter tips 220487, hyperherm HSD130 swirl ring 220529, 130A swirl ring 220488, HSD130 Shield 220532, 220536, 220491, plasma cutter water tube 220937. plasma retaining cap 220578,
| Machine | HEC NO. | Ref NO. | Description |
|
HSD 130 |
H03528 | 220528 | Electrode,(Air)45/(Oxygen)50Amp |
| H02487 | 220487 | Electrode,(Air)130/(Oxygen)130Amp | |
| H03415 | 220415 | Electrode,130Amp (N2,H35) | |
| H73529 | 220529 | Swirl Ring,(Air)45/(Oxygen)50Amp | |
| H72488 | 220488 | Swirl Ring,(Air)130/(Oxygen)130Amp | |
| H13525 | 220525 | Nozzle,45Amp (Air) | |
| H13530 | 220530 | Nozzle,50Amp (Oxygen) | |
| H13492 | 220492 | Nozzle,130Amp (Air) | |
| H13489 | 220489 | Nozzle,130Amp (Oxygen) | |
| H13535 | 220535 | Nozzle,130Amp (N2,H35) | |
| H33578 | 220578 | Retaining Cap 45/50/130Amp (Air,Oxygen) | |
| H33534 | 220534 | Retaining Cap 45/130Amp (N2 and F5,H35) | |
| H23532 | 220532 | Shield,(Air)45/(Oxygen)50Amp | |
| H22536 | 220536 | Shield,130Amp (Air) | |
| H22491 | 220491 | Shield,130Amp (Oxygen) | |
| H03415 | 220415 | Electrode,130Amp (N2,H35) | |
| H03535 | 220535 | Nozzle,130Amp (N2,H35) | |
| H33534 | 220534 | Retaining Cap 45/130Amp (N2 and F5,H35) |
Technical Support:
Plasma cutting technology
Improve the cutting quality of the ten steps
7 cutting torch and workpiece perpendicular to
If the cutting torch and the material is not vertical, will cut out the angled slot. From the two aspects to check if the torch and workpiece angle of 90 degrees.
8 confirm the cutting direction
The good side is always on the cutting surface along the direction of walking on the right side of the torch (assuming the use of vortex ring is right)
9 setting the initial arcing distance
In the mechanical cutting system based on the arc starting distance guide line (see Rev. Arc adjustment range table) manually adjust the initial starting arc distance. The locking voltage regulator is highly regulated until the test cut and other parameters are determined.
4, adjust cutting speed
Select the initial cutting speed according to the cutting diagram in the operation manual. First cut and observe the angle of the plasma arc cutting workpiece. And then adjust the cutting speed to get the correct cutting arc angle.
