Feature
Support Multi Rate 1.25-10.709Gbps 1310nm FP and PIN receiver
SFI electrical interface
SFP+ MSA package with duplex LC connector Hot pluggable
2-wire interface for integrated Digital Diagnostic monitoring
Very low EMI and excellent ESD protection +3.3V power supply
Power consumption less than 1 W
Operating case temperature: 0~+70°C
Applications
High-speed storage area networks
Computer cluster cross-connect
Custom high-speed data pipes
LTE optical repeater application
Description
FPSPP311GL-10 is a high performance, cost effective modules, which is supporting Multi Rate 1.25-10.709Gbps, and transmission distance up to 10km on SM fiber. The transceiver consists of two sections: The transmitter section incorporates a 1310nm FP driver and re-timer. The receiver section consists of a PIN photodiode integrated with a transimpedance preamplifier (TIA). The module is hot pluggable into the 20-pin connector. The high-speed electrical interface is base on low voltage logic, with nominal 100 Ohms differential impedance and AC coupled in the module.
The optical output can be disabled by LVTTL logic high-level input of TX_DIS. Transmit Fault (Tx_Fault) is provided to indicate that the module transmitter has detected a fault condition related to laser operation or safety. Loss of signal (RX_LOS) output is provided to indicate the loss of an input optical signal of receiver. A serial EEPROM in the transceiver allows the user to access transceiver monitoring and configuration data via the 2-wire SFP Management Interface. This interface uses a single address, A0h, with a memory map divided into a lower and upper area. Basic digital diagnostic (DD) data is held in the lower area while specific data is held in a series of tables in the high memory area
