Lamborghini LDT-LARA & LDAS CF SYSTEM Auto Repair Data Software Digital Inspection Videoscope EPROM Programmer

Lamborghini LDT-LARA & LDAS CF SYSTEM




LDT-LARA & LDAS CF SYSTEMLamborghini Diagnostic Tester

1996 to 2010+ (Diablo, Gallardo & Murcielagos)

Current system the factory & dealers use to service Lamborghini's. Diagnose and repair Lamborghini Models to current year! Perform e-Gear Clutch service to all Murcielago and Gallardo Models to current year and 100's of other functions.


ALL Coupe & Roadster/Spyder
Models Supported:
Diablos (1996 - 2001)
Murcielago (2002 - 2006)
Murcielago LP640 (2007 - 2010)
Murcielago LP670 SV (2010)
Murcielago Revention
Gallardo (2002 - 2008)
Gallardo LP560-4 (2009 - 2010)
Gallardo LP550-4 (2010)

Kit Includes:
- Original Laptop Computer- Panasonic CF52
- LARA-AS Interface
- LDAS USB Interface
- K-Line adapter , AirBag & ABS Interface
- FULL Cable Set - OBD 2008,OBD 2010, CAN & Serial BUS
- Software ABS, AirBag, LDAS-32, LaRA-AS
- Tool bag

The LaRA-AS system

(Lamborghini "RA" Acquisition System) is a proprietary 32 bit diagnostic system developed for Lamborghini to further enhance and control GFA, LIE and other body control modules.

It consists of the following items:

Laptop Computer (generally factory preconfigured Panasonic though book
Programmed LaRA-AS electronic Interface
3 Cables specifically for Gallardo pre 2009, Murcielago and 2010+ Gallardo's
the software that supports up to 2010 Models

The LaRA-AS system was developed to allow dealerships secured limited access to onboard computer parameters and functionality. It allows dealer capabilities to access the Lamborghini Oracle database system. If you are not a Lamborghini Dealership this functionality is not available to you, such as Key programming.

Functions:

1. ECU Identification (Part number, Software version and status)
2. Erase Fault Memory codes
3. Egear Snap file reading
4. Control Unit Identification (Displays a list of every control unit in the car, including the part number and software version)
5. Setting the ABS/ESP control unit "AirBag" (Gallardo) (Murci and Diablos use the ABS/Airbag separate software and hardware)
6. Setting the A/C control Unit Functions
7. E-gear Snap
8. Actuator testing (Waring lights, Antitheft and door closure, lights, wiper and nozzels test, ESP lock and unloc test, Radio speakers, Navigation speaker, TV Tuner test, Climat control flap test
9. Egear flash programming (Pump bleeding, read and write clutch functions)
10. Transport and normal setting (for transporting vehicle)
11. E-gear PIS valve procedure
12. Gallardo Spyder Soft top calibration
13. Gallardo Spyder and Murci Roadster Roll over protection testing


The LDAS-32 system
(Lamborghini Data Acquisition System) is a proprietary 32 bit diagnostic system developed for Lamborghini.

It consists of the following items:

Laptop Computer (generally factory preconfigured Panasonic though book
Either a LPT port or USB LDAS Electronic Interface
PC-CAN cable to connects to the diagnostic port in the Lamborghini (Not to be confused with the OBD connector)
Encryption Key used to operate the software that supports up to 2010 Models

The LDAS provides for the following diagnostic procedures:

1. Display of real time all of the engine sensors for both banks
     To include but not limited to (based on model and year):

RPM, MAP, PA1024 (Accelerator pedal opening percentage), Water temp, Air Temp, Engine Sync, Oil Temp, Mixture Strength, Catalytic Converter Temp, ECU start time, Oil Pressure, Idle Status, Barometric pressure, Idle Speed, Fuel Pressure, Engine Spark Advance, Crank Phase, Ignition Timing, Battery Voltage, Spark Advance, Tank pressure, Radiator fan status, Plenum Valve status, Purge solenoid status, Purge Fuel density, Throttle opening percentage, Throttle position read (left and right banks), Torque request from engine, Torque requested by pedal, Throttle pedal signal and opening percentage, O2 sensor management, mixture strength to Lambda, Self learning timing, Post-Cat sensors, Idle self timer, Idle RPM target, RPM errors, AC control RPM request, DBW Correction management, VVT Management, and Engine Sync data.

2. Immobilizer data, displays the Timer status for the theft detection system
3. Lifting system Diagnosticsfor Hydraulic ECU pressure, User button control status, Solenoid vale control, Target reach, upper and lower limit pressures, Pressure sensor diagnostic, Up and down vale diagnostics.
4. MAP real time strip screen for calibrating Throttle bodies.
5. Misfire bank status and cylinder identification
6. Accelerator pedal adjustment and Engine Idle speed adjustment
7. Total engine operating time display
8. Start up attempts
9. Warning tables & Errors
10. GFA data logger (Top speed, how long the event lasted, operation time of Injection system
11. Display Type of map, version, year, VIN of the ECU's
12. Reset Diagnostic data
13. VIS/VVT control, Manual fan energizing, control manual activation of the air pump
14. Air Intake & Spoiler adjustment (Murci)