Electric permanent magnetic change mold Systems for 2100T Injection
During the Mag phase the magnetic flux is short-circuited outside the magnetic surface safely clamping the mold with a very limited magnetic depth so as not to affect any internal part of the engaged mold.
During the Demag phase the magnetic flux is short circuited inside the magnetic module frame,perfectly releasing the mold for its change over.
A magnetic clamping mould avoids deformation and avoid the effect of internal tension.Clamping force evenly distributed throughout the contact surface, Rather than a traditional clamping press several points, Make mould injection molding, stamping out products maintain consistency.
Rapid mold change - saving more than 90% mold changing and installation time, suitable for the current high-speed competive era, promoting an enterprise competition ability, being fast, on-time delivery, reducing production cost, saving production time.
Supply specification:
• Permanent-electro magnetic modules, in
steel monoblock, for fixed and moving platen,
with centering ring.
• Fixing and ejectors holes, based on standard
(EUROMAP / SPI / JIS).
• Electronic control unit, IP54 cabinet, provided
with interface for PLC, UCS current Control
Unit.
• Remote push-button for MAG/DEMAG cycle,
with signal lamps and interlock key.
• Wiring cables: control unit-modules, interface
and power supply connections.
• No.1 proximity sensor for each platen installed
on DM-QMC modules.
• Set of fixing bolts with nogs.
• Instruction book and CE certifications.
