Gravity Feed Double Blister Spray Gun HVLP
| Model | R1000 |
| Type of feed | Gravity |
| Standard Nozzle | 1.3mm |
| Operating pressure | 2.0bar |
| Pattern Width | 180-260mm |
| Air consumption | 4.1-4.5cfm |
| Paint Capacity | 500cc |
Spray Gun Trouble Shooting:
Symptom | Problem | Solution |
| Spray gun's body fluttering or spitting | 1.Spray gun's material level too low. 2.Container tipped too far. 3.Loose spray gun's fluid inlet connection. 4.Loose or damaged spray gun's fluid tip/seat. 5.Dry or loose spray gun's fluid needle packing nut. 6.Spray gun's air vent clogged. | 1.Add material into spray gun's container. 2.Hold more upright. 3.Tighten. 4.Adjust or replace the spray gun's fluid tip/seat 5.Lubricate or tighten. 6.Clear the spray gun's vent hole. |
| Pattern is arc | 1.Worm or loose spray gun's fluid nozzle. 2. Spray gun's material build up on air cap. | 1.Tight or replace spray gun's fluid nozzle. 2.Remove obstructions from holes, but use meatal objects to clean. |
| Patterm is not evenly spread | 1.Materoa; build up on air cap. 2. Spray gun's fluid nozzle dirty or worn. | 1.Clean or replace spray gun's air cap. 2.clean or replace spray gun's fluid nozzle. |
The center of pattern too narrow. | 1. Spray gun's material too thin or not enought. 2.Atomization air pressure too high | 1.Regulate material viscosity 2.Reduce air pressure. |
Pattern width of fan sharp is not enough | 1. Spray gun's material too thick 2.Atomization air pressure too low | 1.Regulate material viscosity 2.Reduce air pressure |
Air leaking from air cap without pulling trigger | 1.Sticking spray gun's valve stem 2.Contaminate on spray gun's air valve or seat 4.Broken spray gun's air valve spring 5.Bent spray gun's valve stem | 1.Lubricate spray gun's valve stem 2.Clean spray gun's air valve or seat 4.Replace spray gun's air valve spring 5.Replace spray gun's valve stem |
Spray gun fluid leaking from packing nut | 1.Spray gun 's packing nut loose 2.Spray gun 's packing worm or dry | 1.Tighten, but do not restrict needle 2.Peplace or lubricate (non-silicone oil) |
Excessive overspray | 1.Too high atomization pressure 2.Too far from work surface 3.Improper stroking (arcing ,spray gun motion too fast ) | 1.Reduce pressure 2.Adjust to proper distance 3.Move at moderate pace, parallel to surface |
| Spray gun will not spray | 1.No pressure at spray gun 2.Spray gun 'sfluid control not open enough 3.Spray gun's fluid too heavy | 1.Check spray gun's air lines 2.Open spray gun's fluid control 3.Thin spray gun's valve stem fluid or change to pressure feed system |
Thank you very much for your kind inquiry!
